I would like to seek advice on the following matter. I apologize if this is not the right forum but I cannot find anything on the internet. I hope to get the opinion from those have the experience and knowledge.
I bought a used engine block from Europe to replace the one in my car. After receiving the engine block, the second main bearing housing was previously repaired. It was also missing a slot for the main bearing.
I have never come across such a repair before. My main concern is whether the repair is acceptable (see attached photo). Can it withstand the load and vibration of the engine?
Secondly, as the slot for the main bearing is missing, is it all right to grind off the locating lug on the main bearing in order for it to fit into the housing?
Thank you for your attention.
I bought a used engine block from Europe to replace the one in my car. After receiving the engine block, the second main bearing housing was previously repaired. It was also missing a slot for the main bearing.
I have never come across such a repair before. My main concern is whether the repair is acceptable (see attached photo). Can it withstand the load and vibration of the engine?
Secondly, as the slot for the main bearing is missing, is it all right to grind off the locating lug on the main bearing in order for it to fit into the housing?
Thank you for your attention.