I hate to break a set (I also have an Aciera F4), but I need the space, and the F2 doesn't get much use. See below for photos. This is a perfect home shop machine - small enough to handle, big enough to do real work, and way, way, way nicer than new Asian for the same money.
S/N 25180 Made in Switzerland 1960s vintage
Horizontal and vertical spindle modes with angular adjustment in the vertical mode
W20 spindle taper with drawbar
0.8 horsepower
150-300-600-1200-2400-4800 RPM via three-step pulley and two-speed gearbox
Infinitely variable motor speed via TECO FM100 variable frequency drive (VFD) (included in sale – runs on 220-V 20-A single-phase circuit)
X – Y – Z travels (longitudinal x cross x vertical) 8.9” x 4.9” x 8.9” (225 mm x 125 mm x 225 mm)
Both screw and lever feeds available
Inch screws and graduated collars
X – Y – Z backlash 0.003” x 0.002” x 0.007” (screws are like new)
Two-way tilting angular table 5” x 18” (130 mm x 450 mm)
Cabinet base with copious storage
Built-in work light
Original paint
Width x depth x height 70” x 44” x 61” (1770 mm x 1120 mm x 1540 mm) (Width is with the doors wide open – width is 31” with the doors shut)
Weight approximately 600 lb. (275 kg)
Sale includes:
W20 collets: 3/32”, 1/8”, 5/32”, 3/16”, 1/4”, 5/16”, 3/8”, 1/2”, 5/8” & 3/4”
W20 long arbors with spacers: 1/2” & 3/4”
W 20 stub arbor: 1/2”
W20 arbor blanks: stub 2” and long 1/2”
Horizontal arbor support
Vertical spindle attachment
T-nut and stud clamping set
Wrenches
Spare spindle needle bearing
Operation, Maintenance and Parts Manual (with detailed exploded assembly views)
Spindle oil gun
Way oil gun
$2,400 + shipping. I will strap to a pallet for free. Crating extra. Forklift available for loading.
More photos in the next post.