Houdini
Titanium
- Joined
- Nov 28, 2017
I was told by coolant manufacturers that Aluminum complex grease is one of the best to not contaminate coolant, and low washout, I use Lubriplare No. 1444 its a NLGI2 I get it from Motion Industries. We use this in the lathe chuck also, and the ballscrews of our old Nakamura box way turning center.yeah I've only been using the green/gray pads, tho will lay off and get some
what grease do you use? looks like Haas recommends Red-I tho it's hard to come by, will Mobile XHP-222 do the trick? Haas has it listed with Red-I on their website, from my research they seem pretty close.
what specifically doesn't look great about the taper? just the rusting?