aribert
Cast Iron
- Joined
- Jul 2, 2008
- Location
- Metro Detroit, MI
I have acquired 4 IMS/FIMS tool holders that I have no need for. All holders start with the number 3 which according to this thread, post #9 (https://www.practicalmachinist.com/...er-radius-turning-holder.407336/#post-3992002) implies that these have the same dovetail size as an Aloris. Visually holding a real AXA and one of these back to back the dovetails appear to align. The height adjust on these tool holders appear to be similar concept as KDK toolholders.
FIMS-3-1 triangle insert
FIMS-3-B takes up to a 3/4 inch shanked tool/tool holder
IMS-3-J square insert
(F?)IMS-3-E if there is an "F", it is covered up by the block that holds the nominal 5/8 height cut off blade
$30 + $10.25 USPS flat rate shipping. PayPal or check/MO (shipping delay till check/MO clears)
FIMS-3-1 triangle insert
FIMS-3-B takes up to a 3/4 inch shanked tool/tool holder
IMS-3-J square insert
(F?)IMS-3-E if there is an "F", it is covered up by the block that holds the nominal 5/8 height cut off blade
$30 + $10.25 USPS flat rate shipping. PayPal or check/MO (shipping delay till check/MO clears)
