I lubed the feed rod clutch with Super Lube.
and then slid it together.
A 6-32 dog point set screw then gets inserted into the clutch.
I then set the feed rod stop collar for now, but will need to readjust its position once I have a chuck on the lathe.
I then slid the lead screw into the gear box collar and drove in its #3 tapper pin to secure it.
I can now install the Feed Rod Plate. I being by adding Tef-Gel to the bolt threads.
I slide the Feed Rod plate onto the two shafts, and then very loosely tighten then its mounting bolts.
I then drive in its large alignment pin.
I then place the retaining ring onto the lead screw.
and then pack the cavity full of Super Lube as there is no provision to lubricate this under normal operation. I can then tap in its dust cap.