B.A.D.Kustoms
Plastic
- Joined
- Dec 1, 2020
- Location
- Ft. Collins
I'm new to Fusion turning but seriously thinking it's lacking control.
I'm boring a 6.35mm hole out to 7.50mm with a 5.40mm solid carbide boring bar.
That being said the tool is far too large to cut to center which seems to be the only option I have doing a Profile Finish. I've tried roughing too.
That's not my only bone to pick though, also defining boring bars under turning there is no option for a round shank bar. If you make a round boring bar under hole making you can achieve the round bar but then you can't use the tool for profile finishing in turning.
Any help would be greatly appreciated, thanks.
-Brad
I'm boring a 6.35mm hole out to 7.50mm with a 5.40mm solid carbide boring bar.
That being said the tool is far too large to cut to center which seems to be the only option I have doing a Profile Finish. I've tried roughing too.
That's not my only bone to pick though, also defining boring bars under turning there is no option for a round shank bar. If you make a round boring bar under hole making you can achieve the round bar but then you can't use the tool for profile finishing in turning.
Any help would be greatly appreciated, thanks.
-Brad