What's new
What's new

Gildemeister Sprint 42, no 8000 or 9000 programs

LarsOlavTveito

Plastic
Joined
Sep 26, 2022
I have purchased a used Gildemeister Sprint 42 with Fanuc 310is control. As I am used to Siemens 840d on my other machine, it is a little bit new to me. Have managed to make some parts, but the bar feeder, an Iemca Boss 545, will feed out material, but havent got it to change bars yet. When searching for a solution, it seems that there usually is some 9000 programs and/or 8000 programs that should be in the control that may be used to control such things. As far as I can see, there are no 9000 or 8000 programs in the control at all. May be that the previous owner has deleted all programs before selling the machine. Is there anyone that has such a machine that can check if there is any factory installed programs that should be there?
 








 
Back
Top