Waakzaamheid
Cast Iron
- Joined
- May 17, 2010
- Location
- Massachusetts
We are looking at picking up a used Haas as a second op machine that will need to use some pretty long tools. We are currently doing this in our VF2 with an umbrella tool changer. A lot of the used ones come with side mount changers and I'm not sure if my tooling will fit. I'm using a tool holder with an 8 inch projection plus the tool a couple more inches out of that. The only info I can seem to find is it might be a max of 11 inches from the gage line. And I'm not too clear as to what the gage line is. From what I can tell it's essentially where the taper seats into the spindle?
Any help is appreciated, thanks!
Any help is appreciated, thanks!