rjwalker1973
Stainless
- Joined
- Feb 2, 2016
- Location
- Lakeland, Florida
Afternoon folks. I got a question about the live tooling on haas lathes. I was trying to panel program a radius in the yz plane on our haas st25y. Thbe issue I was having was it was peaking in the center and cutting a v instead of a radius. It was pretty basic to basic but for some reason it did not want to cooperate.it was basically this
T101
G54
G19
G98
M133 P1500
G0 X.415 Y.88 Z1.0 M8
G1 Z.1 F50.0
Z0.0 F5.0
G03 Y0.0 Z-.88 R.88
Y-.88 Z0.0 R.88
G1 Z.1
I ended up just using fusion to save time. I figure it is something simple I am over looking like comping the tool which was a .750 4 fl endmill. Anyone have any ideas? Could it be I need to comp it in more in Y?
T101
G54
G19
G98
M133 P1500
G0 X.415 Y.88 Z1.0 M8
G1 Z.1 F50.0
Z0.0 F5.0
G03 Y0.0 Z-.88 R.88
Y-.88 Z0.0 R.88
G1 Z.1
I ended up just using fusion to save time. I figure it is something simple I am over looking like comping the tool which was a .750 4 fl endmill. Anyone have any ideas? Could it be I need to comp it in more in Y?
