What's new
What's new

Help needed

Status
Not open for further replies.

cerro

Plastic
Joined
Oct 14, 2021
I have a Warco Major milling machine and have just bought a set of chuck/collets from Lycorish for £55.29. My problem is when I put the dial gauge on the shaft it has a run out of half a thou very good, but when I move it down to the tool and the nut the gauge goes hay wire there is so much wobble I have cleaned the collet inserts and tried different tools which are brand new but it’s still the same what am I doing wrong Please help as I am new to milling.
 
Status
Not open for further replies.








 
Back
Top