What's new
What's new

Hermle C30U w, Siemens, collision sensor reset

Avikeneng

Plastic
Joined
Nov 21, 2018
Hi,
I just bought a used C30U but have an alarm saying 510104 replace spindle after transport. The spindle was placed in correct position by Hermle tech and the machine was set ready for shipment. I have checked the spindle collision sensor and it’s not activated now, but it seems like once the alarm is triggered it stays until you clear it in the plc or a parameter. Does anyone know how to do this on a Siemens 840 pl control?

Once the alarm is active I cannot run the machine, not even JOG the axis.

Thank you
/Johan
 








 
Back
Top