What's new
What's new

identification of internal grinding quills taper

mariusdragomir

Plastic
Joined
Apr 6, 2019
Hello everyone!
Recently I bought some internal grinding quill from a used local market in Romania.
I need your help to identify what kind of type it is, including taper.
Please see my below photo attached togather with dimensions.
Any reference is very useful to me.
Thanks in advance!
Respect to all machinists!
 

Attachments

  • 20220208_112926.jpg
    20220208_112926.jpg
    87.8 KB · Views: 65
help to identify what kind of type it is, including taper.
mariusdragomir, you are missing the two or three dimensions that would be most helpful in identifying what this fits. What are the spigot diameter and (assumed) internal thread at the right end? What is the actual taper? See if you can measure the included angle. What is the small diameter of the taper? What is the length from the large diameter to the small diameter?
 
mariusdragomir, you are missing the two or three dimensions that would be most helpful in identifying what this fits. What are the spigot diameter and (assumed) internal thread at the right end? What is the actual taper? See if you can measure the included angle. What is the small diameter of the taper? What is the length from the large diameter to the small diameter?

Given the dimension mariusdragomir provided, the included angle is 27° (small diameter: 15.07 mm = .593", large diameter: 19.96 mm = .786", length: 10.18 mm = .401").

Paolo
 








 
Back
Top