Bad.Cyborgh
Plastic
- Joined
- Jan 11, 2022
- Location
- Auckland - New Zealand
Good day all
IEMCA VIP80 E (2005) removed from a NLX2500/700 and put into storage. Hardly used but electrical / electronics' did boot every time the lathe was switched ON. As a jobbing shop we never had a use for it but the salesman was really convincing. Unit is complete with interface and all documentation including DMGMori documentation on MORI bar feed interface. If interested please email me.
IEMCA VIP80 E (2005) removed from a NLX2500/700 and put into storage. Hardly used but electrical / electronics' did boot every time the lathe was switched ON. As a jobbing shop we never had a use for it but the salesman was really convincing. Unit is complete with interface and all documentation including DMGMori documentation on MORI bar feed interface. If interested please email me.
Last edited: