Houdini
Titanium
- Joined
- Nov 28, 2017
Anyone have real world experience deburring complex organic curves on 6061 Aluminum parts.
We have some parts with a lot of 3 dimensional curves that need deburring after the machining.
they are 1.5" round by 24" long 6061 shafts with a few curves.
We need to do batches of 240 parts monthly, and hand deburring with a Noga deburr tool and a triangle knife is too time consuming.
Wish I could just throw them in the tumbler, but they are too long and heavy, they would just beat each other up.
Real world Suggestions?
We have some parts with a lot of 3 dimensional curves that need deburring after the machining.
they are 1.5" round by 24" long 6061 shafts with a few curves.
We need to do batches of 240 parts monthly, and hand deburring with a Noga deburr tool and a triangle knife is too time consuming.
Wish I could just throw them in the tumbler, but they are too long and heavy, they would just beat each other up.
Real world Suggestions?