Wish I had more information, but I'm wondering if anybody has encountered this before.
We're using the debur toolpath with a ball endmill to clean up a part in Mastercam 2023. The axis control is set to 3x and there doesn't appear to be anything out of the ordinary. We are able to successfully post using a Haas post, but when we use the generic 3x FANUC post it errors out. The log output doesn't actually provide any details. Going to continue investigating, but wondering if anybody has seen this.
We're using the debur toolpath with a ball endmill to clean up a part in Mastercam 2023. The axis control is set to 3x and there doesn't appear to be anything out of the ordinary. We are able to successfully post using a Haas post, but when we use the generic 3x FANUC post it errors out. The log output doesn't actually provide any details. Going to continue investigating, but wondering if anybody has seen this.