Hello everyone,
I have a Matsuura 600H, Yasnac MX3 controller. I have been loading programs without any issues what so ever. All of a sudden with no alarms or messages it started scrambling jumbling and adding characters mid program. It starts out fine then quickly goes off the rails.
I reloaded the software
Tried adjusting baud rates
Re made the entire program from scratch.
I can send from the machine to the PC with no issues. It’s just from the PC to the control that’s an issue.
I have a new cable coming to try, but if that doesn’t work I’m not sure what else to look at.
I am not electronically savvy.
I have a Matsuura 600H, Yasnac MX3 controller. I have been loading programs without any issues what so ever. All of a sudden with no alarms or messages it started scrambling jumbling and adding characters mid program. It starts out fine then quickly goes off the rails.
I reloaded the software
Tried adjusting baud rates
Re made the entire program from scratch.
I can send from the machine to the PC with no issues. It’s just from the PC to the control that’s an issue.
I have a new cable coming to try, but if that doesn’t work I’m not sure what else to look at.
I am not electronically savvy.