What's new
What's new

Matsuura yasnac mx3 program scrambled

Billet454

Plastic
Joined
Jul 16, 2021
Hello everyone,
I have a Matsuura 600H, Yasnac MX3 controller. I have been loading programs without any issues what so ever. All of a sudden with no alarms or messages it started scrambling jumbling and adding characters mid program. It starts out fine then quickly goes off the rails.
I reloaded the software
Tried adjusting baud rates
Re made the entire program from scratch.
I can send from the machine to the PC with no issues. It’s just from the PC to the control that’s an issue.
I have a new cable coming to try, but if that doesn’t work I’m not sure what else to look at.
I am not electronically savvy.
 

Attachments

  • B25EC7EF-55A0-497B-9D7A-E55E3DF9ED7A.jpeg
    B25EC7EF-55A0-497B-9D7A-E55E3DF9ED7A.jpeg
    699 KB · Views: 15
Was it the cable?
No Sir. Its bad memory. If I load too many programs it starts to fragment everything. Yaskawa had me re gen the system, which I would only recommend as a last resort, and now my pallets don't work. So out of the pan and into the fire I guess.
 








 
Back
Top