What's new
What's new

Mitutoyo Geopak Inspection Report

PROBE

Hot Rolled
Joined
Jan 23, 2003
Location
Tel Aviv, Israel
Hi Guys,
I was trying to get the information on CNC forum, unfortunately no results. Hopefully this subject oriented forum will have some answers for me.

The test part as per attached sketch (simplified ISO10791-7 TEST PIECE) was measured on Mitutoyo CMM.
I am not an expert in Mitutoyo CMM GEOPAK Inspection software. Seems that the report (attached too) was "cooked", as report Line Numbers are not following. Shouldn't they follow like 1,2,3,4 etc. Seems that the coordinate system was realigned after LINE element in line 9 of the report was measured. Shouldn't this fact appear in next line of the report ? Shouldn't the realigned LINE data appear in the report ?
I would appreciate very much if somebody could also attach the sample of not edited GEOPAK report.
Thanks in advance.

Stefan
Cogito Ergo Sum
 

Attachments

  • 27.6.2021.pdf
    37 KB · Views: 5
  • TEST PIECE 4.pdf
    9.3 KB · Views: 4








 
Back
Top