Mori Seiki horizontal probing

[gsannes]

Hey guys,
I am trying to probe a bore 8.600" on a part. We are using a large washer with a stud through the same bore to hold the part to the fixture. We have cutouts in the washer to reach through with the probe. What variable do I need to go off center 4.00" before going into the bore so I can miss the washer? I know you can do that for o.d diameters, but what about i.d. diameters?

 

[gsannes]

We are running Mori Seiki probing software. (G320)

 

[13engines]

Can't you just program normal machine G1 G2 etc. moves to bring the probe around into position, then call the Probing routine?

 

[Booze Daily]

Unless there’s a pre-made cycle template you’re gonna have to program all the moves. I do it in incremental

Once it works properly I like to put the probing code after the M30 so next time you’re good to go.