Hi all ive recently acquired a new small mill and i want to connect it with a vfd.
But the motor as a dual speed that is changed on a switch.
Motor has 6 leads and it says in the plate that is 4 pole and 8 pole.
Voltage only says 380 but my vfd outputs 220.
Is there any way to connect this to the vfd?
But the motor as a dual speed that is changed on a switch.
Motor has 6 leads and it says in the plate that is 4 pole and 8 pole.
Voltage only says 380 but my vfd outputs 220.
Is there any way to connect this to the vfd?