Need to make a new 10L cross feed bushing

[Bklimek]

I recently picked up a 10L to replace my 9A but it's got a couple of problems I have to correct first, the main one being a broken cross feed bushing. I feel pretty confident I can make a replacement for it, but the way it broke I don't feel great that I've got a good overall dimension on the part. I've been digging around and found a bunch of posts about repairing/reproducing these and even some sketches, but they're pretty much all for the large dial version which looks like it's longer. By any chance does anybody have a sketch of one of these for the small dial machines, or one that they could get some measurements off of?

 

[Bklimek]

Took a little trial and error to get the length perfect, but I think I've got a workable repair.

 

[Scrapper7]

Would you happen to remember what the thread size was?