Hi there all. 1st post here. Just picked up a Goodell-Pratt 125 lathe locally that came with the 4 jaw chuck and the compound slide. My question is...I read somewhere that the tailstock is a MT0 and the (headstock) is MT1? I'm trying to find a drill chuck attachment for the tail stock so that I can then find drills for boring a hole in stock and tapping it. All I see are tapered pieces of metal with a chuck in the end of it. Is this what I'm looking for? Does it just get pressure fit into the tailstock? Is there a way to remove the current center support (pictured) and replace so that it is attached better? I've never used a metal lathe so any help in starting with these or pointing in the right direction would be great. As well as drills and cutting bits for it as it only came with one (rounded unfortunately). I did manage to figure out disassembly and such...so that's good (any recommendations for grease are welcome also).Thanks everyone for any help.