just curious, would you happen to know how to change the tonnage type on a hurco autobend 10 system, i have a 100t niagra press that is on type 3 so i cant get it set up with out getting max tonnage exceeded , typ1 or 2 dont use coining so it doesnt check for tonnage. hurco email me and sent me manual , but it says type is set up by installer at time of setup ...
or how do i set up a generic tool library to get this at least up and running without errors . thanks so much for any advice.
or how do i set up a generic tool library to get this at least up and running without errors . thanks so much for any advice.