Always the glutton for punishment Ive aquired a 97 Kitamura Mycenter2x.
Looks like it was never used with a pallet changer. Fairly low cutting hours if the control is to be
believed. On time is high however.
10k spindle and Yasnac I80 with high speed option board.
But the manual is terrible compared to the old Deckel manuals.
Does not show exactly where oil tanks are!
It appears to have four:
1) Cylindrical one up high next to spindle motor. What is this? Spindle lube or cooling oil?
The sight glass on right side of head is very low.
2) Air oil mister with red oil in it. Made by Vogel
3) Central way lube pump
4) Hydralic pressure pump (I think)
The machine blows air from the spindle area continuously. I suspect it was relay controlled but bypassed to help ensure spindle is misted more.
Between that and the spindle turbo blower I need some acoustic wall panels.
Looks like it was never used with a pallet changer. Fairly low cutting hours if the control is to be
believed. On time is high however.
10k spindle and Yasnac I80 with high speed option board.
But the manual is terrible compared to the old Deckel manuals.
Does not show exactly where oil tanks are!
It appears to have four:
1) Cylindrical one up high next to spindle motor. What is this? Spindle lube or cooling oil?
The sight glass on right side of head is very low.
2) Air oil mister with red oil in it. Made by Vogel
3) Central way lube pump
4) Hydralic pressure pump (I think)
The machine blows air from the spindle area continuously. I suspect it was relay controlled but bypassed to help ensure spindle is misted more.
Between that and the spindle turbo blower I need some acoustic wall panels.