huntinguy
Cast Iron
- Joined
- Dec 17, 2006
- Location
- Washington
Can you program the block skip function off and on using G code?
What is the best way to put a Z fixture offset in using G code programming. I Guess I could use a variable but.... My book says G10 is a shut off for G11. I have run 7000s in the past that used G10 for setting fixture offsets... What is the deal?
What is the best way to put a Z fixture offset in using G code programming. I Guess I could use a variable but.... My book says G10 is a shut off for G11. I have run 7000s in the past that used G10 for setting fixture offsets... What is the deal?