What's new
What's new

okuma P200 robot interface

jhearons

Cast Iron
Joined
Sep 16, 2003
Location
riverside, ca, usa
How difficult is it to interface a robot with a P200L control?
We are looking at a collaborative robot to load and unload. Okuma wants $$$ for their interface and $$ to install. It is understood that robots are not cheap, but is there a more palatable solution?
 
I use an independent Tech that is good with Okuma. He resembled my mill turn and took the robot interface off when it got back in country. PM me if you want his contact info.
 
How difficult is it to interface a robot with a P200L control?
We are looking at a collaborative robot to load and unload. Okuma wants $$$ for their interface and $$ to install. It is understood that robots are not cheap, but is there a more palatable solution?
There are many machines out there running using just spare M codes to control the robot. Not nearly as clean of an install, but it does work. You do not get all the different feedback and control that you would with the full "Type D" interface.
 








 
Back
Top