Gear and Spline Experts -
I have to make (or have made) a spline that meets an old Air Force / Navy spec from 1953. The spec was canceled in 1993, with no replacement... Thus, I can't imagine it's common...
Luckily, I have the dimensional details of the spline. But I'm not familiar with gear and spline manufacturing. Do I have enough info here that a specialist shop could make this?
Pitch Diam: 0.800000”
Base Diam: 0.692820”
Flat Root
Side Fit
16 Teeth
20/30 Pitch
Involute tooth form
30 degree pressure angle
Major Diam: 0.867” Max, 0.862” Min
Form Diam: 0.727”
Minor Diam: 0.717” Max, 0.707” Min
Thank you!
Jon
I have to make (or have made) a spline that meets an old Air Force / Navy spec from 1953. The spec was canceled in 1993, with no replacement... Thus, I can't imagine it's common...
Luckily, I have the dimensional details of the spline. But I'm not familiar with gear and spline manufacturing. Do I have enough info here that a specialist shop could make this?
Pitch Diam: 0.800000”
Base Diam: 0.692820”
Flat Root
Side Fit
16 Teeth
20/30 Pitch
Involute tooth form
30 degree pressure angle
Major Diam: 0.867” Max, 0.862” Min
Form Diam: 0.727”
Minor Diam: 0.717” Max, 0.707” Min
Thank you!
Jon