What's new
What's new

Parts manual needed for FP2 with motor in the base.

Just went out to the shop and measured the vertical table on my FP2.
It measures 32 3/4 “. +-(830mm).
Guaranteed that machine has 500 mm travels.
Take a look at your slide, should be an inch ruler on top, and it should be marked off to 20+” assuming your machine has inch dials of course.
Cheers Ross
OK, struck out again. Found Wrench's Deckel DVD from 2006 and got a player hooked up to the Mac. All the FP2 manuals on Allen's DVD are for earlier or later machines. i.e. they either showed a machine with a motor mounted in the back, or they showed a machine with On/Off buttons in the middle and 400mm travel.