Supermax YCM-2GS Combination Mill

[Cortman]

Hello,
Recently purchased an older Supermax combination mill, YCM-2GS, I have a few questions about the mechanics of the machine and would like to ask an owner of this machine a few questions? Probably not a lot of these machine still around. Any source of parts? Find a few manuals on Ebay.
Thanks! CORTMAN

 

[Karl_T]

I have run this exact machine for 20 years. Last time I needed parts, they were available. Sorry do not remember where. start here: https://www.ycmcnc.com/en/service

Here's a similar manual that i got free. sorry too large to upload, PM me your email address.

 

[Karl_T]

I will say replacing the spindle drive belt is an effing awful job. Something about this reeves drive that kills the belt. After the second failure, i went to a VFD on the drive motor. This makes speed changes super easy AND have not replaced the belt again.