Froneck
Titanium
- Joined
- Dec 4, 2010
- Location
- McClure, PA 17059
Is the a Taper cutting device to cut the approx. angle of a Moore tool holder? I purchased 3 Susta brand tool storage holders from HGR some time ago. I have attached the frame near my Moore #3 Jig Borers. I have 2 frames of 11 holders each full of holders. However a number of the hard Red plastic inserts were broken so I can't fill another holder, actually none though I managed to glue 2 of them. However I need the full tray of 11. Found Red Delrin on ebay, it's on the way. Rather than make 11 individual holders to fit into the frame I'll just make one continuous strip with 11 holes.
Cutter does not have to be perfect just enough to support the holders for storage.
Any suggestions as to a tapered reamer of anything else? I'm thinking of using a tapered endmill.
Cutter does not have to be perfect just enough to support the holders for storage.
Any suggestions as to a tapered reamer of anything else? I'm thinking of using a tapered endmill.