michiganbuck
Diamond
- Joined
- Jun 28, 2012
- Location
- Mt Clemens, Michigan 48035
Good Evening,
Sorry to revive this old thread. I am considering the purchase of a tool and cutter grinder. I posted a WTB in the appropriate section of PM and I have received some leads and great advice but most machines are too expensive, too far away, worn out and/or include no accessories whatsoever.
I came across an OK Tool Model 202 grinder and was hoping that anyone who owns or has experience with one would share that information? I have done quite a bit of searching trying to find out more about the grinder and the company and there isn't much available. I found some literature at Vintage Machinery and I stumbled on to this thread.
Any thoughts, opinions, advise etc would be most appreciated.
Thank you.
Joe
You should free download the Cincinnati #2 operators manual (or cinci #1)
It gives TC grinding procedures and shows the needed fixtures.
It is good to have along with any/every TC grinder.
Yes many TC grinders have good manuals, but the Cinci one is free and can sit in your computer or be put on a disk for your use.