Hello, I am new to this forum and just wanted your opinion on what might be the smartest business move to make. I started a shop up in the garage around spring time and have been doing pretty well, always busy running day and night. I started with a 2016 Haas Super Mini Mill and it has worked well for me, although it does have some quirks such as the chip auger constantly being clogged(even with shorter chips), leaky, etc. Im at the point where I’m planning to purchase a new VMC in the Spring Time and move into a shop. I’ve narrowed it down between the haas VF2ss and the DN Solutions (Doosan) DNM4500S. The haas would be around 85k and the DNM would be about $126k but have many more options/speed. After running haas and seeing doosan, I believe doosan to be more robust and better built, but the haas has made me a lot of money too. The main things I’m looking at, Is reliability, service times, accuracy, and lifespan. Haas is about 4 weeks out for service all the time in my area (SoCal) which is very concerning as machines will need service eventually no matter which brand. Not sure if I should try and save some money by buying the haas or if I should go on the high end of my budget with the DNM in hopes that it will outperform and outlive the haas. Just to be clear, not trying to start another Haas Vs Doosan debate as there are plenty of those and I’ve already put hands on both, just looking for opinions on the smartest investment/business decision. Thank you!