moosesgunsmithing
Plastic
- Joined
- Feb 16, 2023
I've been struggling to keep my lathe level, to the point where I am leveling it weekly. I know my slab isn't any good but how does one actually keep their machine staying put on a mediocre slab?
It just rained and my machine was twisted enough to put a 1 thou taper in a two inch part. I'm trying to figure out an inexpensive and simple way to isolate the machine. Could I build a box with pea gravel and place the machine into the gravel on extra large feet? That may take up some of the slab twisting and heaving.
It just rained and my machine was twisted enough to put a 1 thou taper in a two inch part. I'm trying to figure out an inexpensive and simple way to isolate the machine. Could I build a box with pea gravel and place the machine into the gravel on extra large feet? That may take up some of the slab twisting and heaving.