I will probably take it. Could you send a couple of pictures? Adrian is a long way just to check it out. Send me a regular PM or an email. This visitor message board is wierd; I just stumbled on your response. I did not know it was different from the regular PM system. I'll take the motor and belt guards with it.
Frank
Back at you concerning the mill. It's setting in Adrian. Probably weighs 8 or 900 lbs. No problem loading it. It's a 10 B&S taper in the spindle. No tooling but the 10 B&S is still available so you could make up an arbor. Bearings seem good. Table & knee need to be tore apart & cleaned & the gibs tightened. There's belt gards that go with it if you want them & I can come up with a 2 HP 3ph motor if you want that but no single phase.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.