FS: HSK toolholders - ER32 collet chuck and (2) drill chucks

[aribert]

Three HSK tool holders for sale. All three for $140 + $17 for USPS medium flat rate box or available individually for prices noted + shipping. See following 3 postings for individual descritpions, cost and individual images. Note: These were part of a larger auction purchase - I **play** in the R8 / 5C world and have no knowledge of HSK taper toolholders. I am **guessing** that all three toolholders are HSK63A - all toolholders have a nominal 63mm flange OD. Markings on holders as noted in following messages. Ask if you need any nominal measurements taken. PayPal or check/MO (will hold shipping till check/MO clears). If my ask is out of line, please educate me.

 

[aribert]

Lyndex - Japan
ER32-4.00
HSK63A

$45 + $10 USPS padded envelope

 

[aribert]

TMX Toolmex
3-309-6035
HSK6 1/2n-4.33
chuck adjusts smoothly over full range of grip
drill chuck appears to be 1/16 to 1/2 inch grip capacity
some flaking of plating on chuck body
the tip of the jaws are distorted/worn, the balance of the jaws have a good contact surface
jaws / pocket is grimy
taper surface is scuffed
$55 + $10 USPS padded envelope for shipping

 

[aribert]

Mimatic
07.3.1963.2
12682/20
drill chuck appears to be 1/8 to 5/8 grip capacity
jaws move freely/smoothly for the entire grip range
I used a 5/32 allen wrench to move the jaws - probably a 4mm hex socket since Mimatic is a German company
$70 + $10 USPS padded envelope