Hurco KM3P Spindle Fault

[Jasper67]

Hi all,

New to this site and in need of assistance.
I have acquired a KM3P with the Ultimax Multibus control system.
Machine appears to boot up correctly however gives an error message when boot up is complete: Spindle Fault-Check drive system.
Followed all of Hurco’s recommended troubleshooting and also contacted Martin CNC and followed Shane’s advice however still get same message.
Has anyone else experienced this scenario or have any ideas on what may be the cause?
Thanks in advance,
Jim

 

[Dan from Oakland]

Midwest CNC Service, Inc.