Large diameter rings for sale

[vandytech]

I’m not sure if anybody has any use for these, but I don’t know unless I put it out there. We have 80+ pieces of 1026 HFS tubing from our production runs. OD’s run from 10.0 inch to 18.0 inch, with the majority from 11.0 to 17.0. All are 1.0 to 1.25 wall thickness. Overall lengths range from .625 to 1.375. We have been lucky to find a local metal sculpture artist who buys these from us, but he can only use so many. If anyone has any interest, they are $3.00 each. They can be picked up, or we will ship common carrier, freight collect.

 

[plastikdreams]

Elephant bracelets?

 

[richard newman]

Where in PA are you located?

 

[Garwood]

Cut them in half and sell for bandsaw vise clamping devices for short/odd shaped parts.

 

[vandytech]

Where in PA are you located?

NE PA off of I-84

 

[mjr6550]

Near Scranton? I am interested, possibly picking up some. I am in Florida this week. I will check back with you later.

 

[vandytech]

Near Scranton? I am interested, possibly picking up some. I am in Florida this week. I will check back with you later.

About 30 minutes east of Scranton, about 10 miles from Lake Wallenpaupack, and a few miles down from Schrute’s Beet Farm.

 

[plastikdreams]

About 30 minutes east of Scranton, about 10 miles from Lake Wallenpaupack, and a few miles down from Schrute’s Beet Farm.

Beets...bears...Battlestar Galactica

 

[michiganbuck]

The 10" ones would be great face plate set-out spacers.
The same for mill work, set the part on top with a couple hold downs, and then dril, tap, whatever with being off the table.

For the surface grinder one could hang them on the wheel peg board so none of the pegs feel left out.