Hello this is my first post on here. Wondering if you fabulous people could help me out. I work on a Robbie cylindrical grinder and recently I have started to get 2 thou run out in the centre of jobs. The ends are dimensionally parallel. It's just this 2 thou smaller section in the middle.
I have thought it could be push off pressure but it's only stainless so normally it's not that much push off maybe half thou to 1 thou.
So my question is to would you know where this random 2 thou might be coming from?
Thanks in advance
Dani
I have thought it could be push off pressure but it's only stainless so normally it's not that much push off maybe half thou to 1 thou.
So my question is to would you know where this random 2 thou might be coming from?
Thanks in advance
Dani