Turntech
Plastic
- Joined
- Sep 29, 2015
- Location
- Ottawa, Ontario
Hi All,
Been lurking around the board searching for answers to this to no avail so figure I may as well ask. I'm sure that someone here has made adjustments to their G61.1 settings on a Meldas control.
I just installed a basically new old stock 1998 Feeler FV800 with a Mistubishi Meldas 520AMR control. Everything is running great other than a bit of corner gouging above 40IPM. I turned on the G61.1 accuracy mode which solved the issue but the Accel./Decel. rates appear to have never been tweaked in my control and are therefore very slow (about 20ipm around a .250 rad).
Attached are photos of my current settings screen and the parameter functions in the manual. Unfortunately the manual is not much help explaining the functions of F1-8, FM1/2 or the K factor... was thinking of inputting the values used in the manual example in the top right as a start but without knowing what the values affect, I will not be able to tune it very well.
Anyone have experience with these older Meldas's and setting these param's for G61.1?
Cheers
Been lurking around the board searching for answers to this to no avail so figure I may as well ask. I'm sure that someone here has made adjustments to their G61.1 settings on a Meldas control.
I just installed a basically new old stock 1998 Feeler FV800 with a Mistubishi Meldas 520AMR control. Everything is running great other than a bit of corner gouging above 40IPM. I turned on the G61.1 accuracy mode which solved the issue but the Accel./Decel. rates appear to have never been tweaked in my control and are therefore very slow (about 20ipm around a .250 rad).
Attached are photos of my current settings screen and the parameter functions in the manual. Unfortunately the manual is not much help explaining the functions of F1-8, FM1/2 or the K factor... was thinking of inputting the values used in the manual example in the top right as a start but without knowing what the values affect, I will not be able to tune it very well.
Anyone have experience with these older Meldas's and setting these param's for G61.1?
Cheers
