Hello. I recently acquired a used piece of equipment that has a Hainbuch quick change collet chuck on it and I’m wondering if my MicroCentric collets of the same size will work. The MicroCentric collets physically fit in the Hainbuch chuck and the taper angles seem similar. Has anyone tried this and if so, did it work out okay?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Hainbuch and MicroCentric collets
- Thread starter AwanaCmdr
- Start date
- Replies 0
- Views 323
