To make a long story short, I'm setting my tools manually because I need to replace the tool eye. I'm setting my tools off the face of the chuck for the Z with a magnetic base height gage for a mill. It actually works pretty well. I have had to change all my parameters for the tool blocks to get them to display correctly. The problem I have now are the soft jaws. What parameter do I change to position the jaws? Because right now if I have a set of jaws that are let say 1 1/2" tall. I have to add about 2" to that # in the jaw data page to get my barriers right. So basically, I run a tool up to the jaws and keep changing the jaw height data until it clears the jaws without a barrier alarm. I would like to get it back to where I can measure the jaw height and enter that for data.
Thanks!
Thanks!
