Hello..
In normal milling during finishing we will use G41 and use wear offset (tool offset compensation) for adjustment
in CNC turning which uses turret with live tooling:
In Fanuc controller during the setup of the living tool we touch off along X and Z and the controller will not ask about the diameter of the tool.. in case of radial tool we will substract Z value geometric offset value to half the tool diameter. Then if we machine using that radial tool during fishing we will adjust the value in Y wear. and finishing program may split into two path one for upper side and another lower side using different Y wear. ( + , -)
In Mazak controller we can work as above but I saw code that uses G41 for live tooling operation on OD I think we can use it as normal milling G41 since the controller ask about ACT-ø and has ACT-ø CO?
I am really confused someone understand that process in both controllers and can explain to me if what mentioned above is correct
Thanks.......
In normal milling during finishing we will use G41 and use wear offset (tool offset compensation) for adjustment
in CNC turning which uses turret with live tooling:
In Fanuc controller during the setup of the living tool we touch off along X and Z and the controller will not ask about the diameter of the tool.. in case of radial tool we will substract Z value geometric offset value to half the tool diameter. Then if we machine using that radial tool during fishing we will adjust the value in Y wear. and finishing program may split into two path one for upper side and another lower side using different Y wear. ( + , -)
In Mazak controller we can work as above but I saw code that uses G41 for live tooling operation on OD I think we can use it as normal milling G41 since the controller ask about ACT-ø and has ACT-ø CO?
I am really confused someone understand that process in both controllers and can explain to me if what mentioned above is correct
Thanks.......