Looking for FP2NC D11 parameters

[Martin P]

As the title says I need the parameters for an FP2NC D11 (Not "A").

I have them for the FP4NC D11, FP3NC D11 and FP2NC TNC355. So from these I should be able to cobble them together, but it would be nice to have the factory values.

 

[AlfaGTA]

Would venture to guess that the only differences would be the soft travel limit values.
Compare the FP4NC with the FP3NC, that should you what would be different on the FP2NC.
Cheers Ross

 

[Martin P]

Yes that is my plan too.
Additionally there is some ambiguity on the Bosch drive side. They have different servos and are very tunable through the parameters. This is for example the accelleration and braking speeds.
I just loaded the parameters from my FP4NC on the FP2NC and that worked fine for boot-up, once I deleted the 4th axis. Now I will adjust the dimensional values.