Good day
Having problem with kitamura mycenter 2x with yasnac i80 controller after replacing the FC260 board i lost all data from the machine.
so after reserialization I entered all parameters that i have in the machine book including timer/counter setting sheet, setting data, pitch error and option parameters.
i can run the axis trough the MANUAL MODE but in AUTO MODE the axis wont move .
The only alarm i have on ATC2 OK1 INITIAL CONDITION i checked all sensors and switch in diag page all look fine.
Any suggestion.
Thanks in advance.
Having problem with kitamura mycenter 2x with yasnac i80 controller after replacing the FC260 board i lost all data from the machine.
so after reserialization I entered all parameters that i have in the machine book including timer/counter setting sheet, setting data, pitch error and option parameters.
i can run the axis trough the MANUAL MODE but in AUTO MODE the axis wont move .
The only alarm i have on ATC2 OK1 INITIAL CONDITION i checked all sensors and switch in diag page all look fine.
Any suggestion.
Thanks in advance.