leeko
Stainless
- Joined
- Jun 30, 2012
- Location
- Chicago, USA
KM 450a Tool and Cutter Grinder.
There are some chips in the paint, and a dent in the corner of the chip pan, but I don't think this grinder has ever been used. The flaking on the ways still looks perfect, and when I got it there was still cosmoline on many surfaces.
There was no motor, so I added a 1/2hp Delta motor and VFD for variable speed control.
Runs off 220v single phase.
Located in Burr Ridge IL
Asking $500
Sent from my SM-G998U using Tapatalk
There are some chips in the paint, and a dent in the corner of the chip pan, but I don't think this grinder has ever been used. The flaking on the ways still looks perfect, and when I got it there was still cosmoline on many surfaces.
There was no motor, so I added a 1/2hp Delta motor and VFD for variable speed control.
Runs off 220v single phase.
Located in Burr Ridge IL
Asking $500
Sent from my SM-G998U using Tapatalk