jbacc
Hot Rolled
- Joined
- May 5, 2009
- Location
- New Jersey
Good Morning,
I'm back once again seeking to tap into the wealth of knowledge of the members of this site and I am most appreciative. Along with my recent acquisition of a KO Lee T&C Grinder was a Norton Brake Controlled Truing Device. Along with trying to figure out how to use it I am wondering if this unit is working properly. There is no resistance whatsoever when spinning the attach grinding wheel by hand, it freely spins... Is this normal? How does the brake part function and when would it kick in?
Thanks in advance for any and all comments, guidance and assistance, I appreciate it.
Joe
I'm back once again seeking to tap into the wealth of knowledge of the members of this site and I am most appreciative. Along with my recent acquisition of a KO Lee T&C Grinder was a Norton Brake Controlled Truing Device. Along with trying to figure out how to use it I am wondering if this unit is working properly. There is no resistance whatsoever when spinning the attach grinding wheel by hand, it freely spins... Is this normal? How does the brake part function and when would it kick in?
Thanks in advance for any and all comments, guidance and assistance, I appreciate it.
Joe